Mineral Water/Bottled Water Plants & Equipment

The demand of water is increasing year after year. The per capita consumption of water has increased and given the limited resource of fresh water it is difficult for the countries to make available its population the fresh water. Keeping this situation in mind many industries have set up mineral water plant in order to obtain fresh drinking water.

Purification.
The first step is water purification. Water obtained from the external source is allowed to pass through the purification unit and then stored in a stainless steel tank. After purification water is taken to the bottling section. Bottling is done as a continuous operation. Purification is followed by bottle Rinsing, Filling and Capping. The unit automatically fills, rinses, and screws the cap on it. Finally mineral water is labeled, packed and marketed.

01. RAW WATER SUPPLY PUMP:

Centrifugal pump in C.I construction is required for feeding raw water from underground/overhead raw water storage tank to PSF to ACF and then on to MCF with required flow rate of per Hour. The pump is fitted with suction/discharge pipe work, isolation valves and pressure monitor

02. PRESSURE SAND FILTER:

This is a FRP Pressure vessel with internal distribution, collection, frontal and interconnecting pipes and requisite valves of SS construction along with one lot of fine sand, silex and pebbles. The necessary instruments like inlet/outlet, pressure monitors and Multiport Valve for Backwash, rinse and filter provided with the system. All the suspended solids and dust particles from the raw water is removed here

03. ACTIVATED CARBON FILTER:

This is a FRP Pressure Vessel with internal distribution, collection, frontal and interconnecting pipes and requisite valves of SS construction along with one lot of fine wash high iodine content carbon flakes. The necessary instruments like inlet/outlet, pressure monitors and Multiport Valve for backwash, rinse and filter provided with the system. All the physical impurities such as odour and colour of raw water is removed here

04. SOFTNER FILTRATION:

This is a vessel contains ION EXCHANGE resins. Softening is done through this ion exchange resins to remove small micro pollutants and hardness.

05. MICRON CARTRIDGE FILTER

The Module consists of Multiple Polypropylene Cartridges with size of 10/5 Micron that prevents micron size particles up to 5 micron. Necessary instrument like inlet/outlet pressure monitor and a Flow indicator is provided with requisite isolation valves.

06. CHEMICAL DOSING PUMP:

This is electronic chemical injection system to remove all scale formation minerals from process raw water to reverse osmosis membranes and is precautionary measure to shield the membranes from blockage of pores. 

07. HIGH PRESSURE PUMP

One No. of Vertical Mounted Multi stage centrifugal High Pressure Pump with SS construction. The High Pressure Pump supply raw water with pressure as required to RO Membranes, where permeate is separated. The necessary instruments like High and Low pressure switch, pressure monitor and requisite isolation valves provided.

07. DESALINIZATION BY REVERSE OSMOSIS SYSTEM

R.O. System removes 90-95% of Total Dissolved Solids by the principle of ‘Reverse Osmosis Process’. This system consist of a Stainless Steel Skid for mounting of high pressure tubes in FRP with resistance of 150 psi for pressure housing spiral wound TFC Membrane elements With necessary control valves at feed, product and reject pipe are provided with required instruments like Low and High pressure switches are provided for safe operation of High Pressure Pump under specified operating conditions. Pressure monitor is provided for pressure indication and control of complete R.O.System. An online flow indicator at product and brine pipe work is provided for controlling desired flow rate and recovery. For monitoring product water quality an online conductivity indicator is provided

08. PRODUCT WATER STORAGE TANK:

This is a  vertical storage tank or HDPE/S.S required for storage of R.O.Product water